V2000-c Rfid Access Control User | Manual

The V2000-C is a single-door multifunction standalone access controller. It supports up to and allows access via RFID card, a 4-to-6 digit PIN, or a combination of both. Operating Voltage: DC 12V ± 10% User Capacity: 2,500 Card Reading Distance: 3–6 cm Active Current: Lock Output Load: Max 3A Operating Temperature: -45°C ~ 60°C 2. Installation and Wiring

💡 Presenting a card immediately after 11 or 13 is often easier than typing card number. V2000-c Rfid Access Control User Manual

It is highly recommended to change the default code immediately. The V2000-C is a single-door multifunction standalone access

V2000-C Terminal Block ------------------------------------------------ +12V → Power supply positive GND → Power supply negative (common ground) NO → Normally open (to lock’s positive unlock wire) COM → Common (to lock’s negative / power supply GND) NC → Normally closed (rarely used with fail-secure locks) PUSH → Exit button (one side; other side to GND) SEN → Door contact sensor (to GND when door closed) ALARM → Optional alarm output BELL → Optional buzzer output Installation and Wiring 💡 Presenting a card immediately

The represents a benchmark in standalone security solutions. Whether you are securing a single-door office, a co-working space, a storage unit facility, or a high-traffic commercial entrance, the V2000-c offers a robust blend of durability, cryptographic security, and user-friendly management.