Fanuc Parameter 1860 Full !!top!!

This parameter sets the number of pulses required to move the axis by one unit of detection. It is part of the "Calculation of Detection Unit" formula. The CNC uses this value alongside the gear ratio and ball screw pitch to determine the "Detection Unit" (the smallest moveable distance the CNC recognizes).

Changing Parameter 1860 will immediately change your machine's zero point. If done incorrectly, the turret or table can crash into the chuck or column. Never change this parameter without first establishing a "Soft Limit" or verifying clearance. fanuc parameter 1860 full

Unit conversion: If parameter 1820 = 100 (0.1 µm/unit), then 1000 units = 0.1 mm. This parameter sets the number of pulses required

This is not an error, but a reminder. Set PWE back to 0. fanuc parameter 1860 full